This is a 9 Pin Direct Install Kit. Make sure this is the right cable for your vehicle by looking at your connector port and consulting the table below. This Cable is an easy one-cable connect to your connector port. If you would like to have an extra port to use for diagnostics without disconnecting the RoadLog get the 9 Pin Y-Connect Cable.
For vehicles with either no diagnostic connector a special OEM connector, RoadLog will need to be installed using the Open Wire direct wiring installation cable kit. Look at your truck to be sure, but as a rule:
|Your Vehicle is:||The Most Common Cable Connection||Part Number:|
|2007 - Current||9 pin connection||3290-90100100|
|2002-2006||6 pin or 9 pin connection||3290-90100200 3290-90100100|
|1996-2001||6 pin connection||3290-90100200|
|1992-1995 with Fuel Injection||6 pin or special OEM or no connector||3290-90100200 (6 pin)|
|Light Duty Trucks and Vans||OBD II connector||3290-90100500|
Standard Cable vs Y-Cable
• The standard cable provides quick plug-and-play installation,but it occupies the diagnostic port and must be disconnected to perform diagnostics with a service tool
• The Y-cable takes slightly longer to install, but retains an open port for fast diagnostics hook-up and provides a cleaner looking installation. The Y-cable contains two diagnostic connectors. One replaces your existing diagnostic connector, and the other plugs into the existing diagnostic connector behind the dash
To hardwire into the vehicle- choose the Open Wire Direct Wiring kit. Some owners prefer the hardwire installation to retain the original appearance of the cab or to provide a theft deterrent.